Honeywell RTH230B מדריך

Honeywell RTH230B
9.2 · 2
PDF מדריך
 · 4 עמודים
אנגלית
מדריךHoneywell RTH230B
RTH230B 69-1800 2/6/05 1/4
The RTH230B programmable thermostat can be used to control:
a gas, fuel oil or electric furnace - 2 or 3 wires
a central air conditioner - 2 or 3 wires
a hot water system with or without pump - 2 wires
a millivolt system - 2 wires
a central heating and cooling system - 4 or 5 wires
Note: These thermostats are not compatible with heat pumps or
multi-stage systems.
Features
System operating mode selection: heat, cool or off
Fan operating mode selection: automatic or on (continuous)
Programmable heating and cooling cycle lengths: 10, 12, 15, 20
or 30 minutes
Temperature display in °F or °C
Battery replacement indicator
5-2 programming including:
- Preprogrammed energy-saving schedule
- Early Start
- Temporary bypass
- Time display (12 h or 24 h)
Filter replacement indicator

2.1 Removing the Old Thermostat

IN ORDER TO AVOID ANY RISK OF ELECTRIC SHOCK, CUT
POWER TO THE HEATING SYSTEM.

n Remove the old thermostat to access the wires.

Warning: If the old thermostat was mounted onto an electrical box,
it was probably powered by 120/240 volts. In this case, this thermo-
stat cannot be used.
o Identify and label each wire (with the corresponding letter on
the wire terminal) and remove them from the terminals.

p If necessary, strip the end of each wire (maximum of 1/4 inch).

q Wrap the wires around a pencil to prevent

them from falling into the wall.

r If the hole in the wall is too big, insulate it

using a non-flammable material in order to
avoid air draughts behind the thermostat.

2.2 Installing the New Baseplate

For a new installation, choose a location approximately 5 feet
(1.5 m) above the floor and on an inside wall. Avoid draughty
areas (top of staircase, air outlet, etc.), dead air spots (behind
doors), direct sunlight or areas near concealed pipes or chim-
neys.

n Remove the thermostat faceplate.

o Loosen the locking screw to separate the thermostat from its

baseplate (the screw cannot be completely removed).

p Tilt the thermostat upwards.

q Mark and bore the appropriate mounting holes (or use the

existing holes). Insert the plastic anchors.

r Pass the wires through the opening of the baseplate and fix the

baseplate to the wall using the screws provided.

2.3 Connecting the Thermostat

The connection of the new thermostat should be similar to that of
the old thermostat; however, it can vary depending on the installa-
tion.
Note: The red jumper wire between the Rc and Rh terminals must
be removed in 2- or 5-wire installations. The jumper must be used in
3- or 4-wire installations if you wish to use the mode selector switch
for the fan.

1. Introduction

2. Installation

RTH230B

Programmable Electronic Thermostat

Installation and User Guide

Display
Adjustment
buttons
System operating
mode selector
Fan operating
mode selector
Programming
buttons
Rh Heating power supply
Rc Cooling power supply
W Heating signal
Y Cooling signal
GFan

עיין במדריך עבור Honeywell RTH230B כאן, בחינם. מדריך זה הוא תחת קטגוריה וסת חום ודורג על ידי 2 אנשים עם ממוצע של 9.2. מדריך זה זמין בשפות הבאות: אנגלית. יש לך שאלה לגבי Honeywell RTH230B או שאתה צריך עזרה? שאל את שאלתך כאן

זקוק לעזרה?

יש לכם שאלה לגבי Honeywell והתשובה לא במדריך?

  • קבלו עדכונים על פתרונות
  • קבלו תשובות לשאלתכם

שאלה ותשובה

מספר השאלות: 0

.הוֹנֵיוֵל RTH230B הוא טֵרְמוֹסטַט מתקדם המתאים לשימוש במערכות חימום וקירור ביתיות. עם עיצוב ייחודי, הטרמוסטט מספק שליטה מדויקת ומתאימה ברמה גבוהה על מערכות החימום והקירור של הבית. המוצר עשוי מחומרים איכותיים ועמידים, המבטיחים יציבות ואמינות לאורך זמן. הטרמוסטט מצויד במסך LCD מואר ובממשק פשוט לשימוש, המסייעים בהגנה על צרכי האנרגיה ובשיפור הנוחות היומיומית של הגורמים. בנוסף, הטרמוסטט מספק אפשרות לתכנות מראש בעלת תזמון מדויק ופונקציות שונות, כגון שליטה בהרטב, זמנים שונים לסקירת האנרגיה, ועוד. הטרמוסטט תומך במערכות חימום וקירור מכל סוג ובנוסף, הוא תואם למערכות אינפרא-אדום ויכול לשלב תפקודים עם מכשירי חימום וקירור אחרים לשליטה מרחוק ונווט פשוט. הטרמוסטט מעניק למשתמש אפשרות לקבע טווח טמפרטורות מדויק, במהלך חום היום וקירור הלילה וזה יעזור לחסך בחשבונות החשמל. בסיכום, ה-Honeywell RTH230B הוא טרמוסטט ביתי מתקדם עם מספר פונקציות מתקדמות שיכולות לשפר את חווית השימוש של המשתמש תוך חסכון באנרגיה ואמינות במערכות החימום והקירור של הבית.

כללי
מותגHoneywell
דגםRTH230B
מוצרוסתי חום
שפהאנגלית
סוג קובץמדריך למשתמש (PDF)

לא מוצאים את התשובה לשאלתכם במדריך? ייתכן שתמצאו את התשובה לשאלתכם בשאלות הנפוצות בנושא Honeywell RTH230B לְהַלָן.

היכן המיקום הטוב ביותר להציב את התרמוסטט?

המקום הטוב ביותר עבור התרמוסטט הוא החדר בו אתה מבלה את רוב הזמן, במקרים רבים הסלון או המטבח. הניחו את התרמוסטט כמטר וחצי מעל הרצפה, לא בשמש ולא על קיר חיצוני.

מהי הרצועה המתה של תרמוסטט?

אם לתרמוסטט שלך יש רצועה מתה, ההתקנה שלך היא, כביכול, 'במנוחה'. התרמוסטט נדלק רק כאשר, למשל, ההפרש חורג ביותר מ -2˚ מטמפרטורת החדר שנקבעה.

מהי טמפרטורת החדר האידיאלית?

לרוב האנשים טמפרטורת החדר האידיאלית היא בין 19 ל-22 מעלות צלזיוס.

האם המדריך של Honeywell RTH230B זמין ב עִברִית?

למרבה הצער, אין לנו את המדריך עבור Honeywell RTH230B זמין ב עִברִית. מדריך זה זמין ב אנגלית.

האם השאלה שלך לא מופיעה? שאל את שאלתך כאן

אין תוצאות